Publicidad
Idiomas disponibles
Idiomas disponibles
6. Operation
6.1. PULLING OUT THE HOSE
C
1. Slowly pull the Hose out to the desired length.
▶ Take care to pull the Hose out in a straight line.
2. To stop the Hose, pull on the Hose again until the locking mechanism gives an audible click.
▶ Do not extend past hose end marking.
3. To adjust the hose stop, release the back stop screw of the stop and move it to the desired po-
sition. Then tighten the back stop screw.
6.2. CONNECTING
1. Connect Hose reel to the compressed air supply. Connect a suitable pneumatic tool to the
pneumatic tool connection.
▶ Comply with the respective manufacturer's operating instructions.
▶ Note the hose's maximum working pressure.
2. Check that all connections are in order.
WARNING! Risk of injury from pressurised hose. Fully relieve hose reel of pressure
after every use. Do not store when pressurised.
6.3. REELING IN HOSE
D
1. To release fastening, slowly pull Hose until you no longer hear the locking mechanism's click-
ing sound.
▶ Hose slides back into casing at controlled speed.
2. Guide Hose while it is reeling in.
7. Maintenance
Interval
Before each use
Immediately
Maintenance work
Check hose, hose guide and
external components for vis-
ible signs of wear.
Check for leaks using soap or
leak finder spray.
Repair defects and damage or
replace.
Use genuine spare parts only.
www.hoffmann-group.com
Performed by
Trained person
Trained specialist for mechan-
ical work.
Contact Hoffmann Group cus-
tomer service.
13
en
Publicidad
