Publicidad
Idiomas disponibles
Idiomas disponibles
3. Connect the appliance with power source, press down the power button, and the defaulted
low steam rate indicator will blink. And there are three modes including low, medium and
high steam rate available, you can select the desired steam rate for each garment according to
your requirement. Make sure that there is enough water in the tank.
4. Turn temperature dial to your desired setting, which is depended on the fabric of garment.
The iron starts heating, and the temperature indicator will illuminate solidly during heating.
Refer to "IRONING TIPS" and "ADDITIONAL TABLE" as below when select
temperature.
5. After a few minutes, the temperature indicator will extinguish, it indicates the soleplate
temperature has achieved the selected temperature. When the indicator of selected steam rate
changes from flashing to illuminating, it indicates that the iron is ready for ironing garment
with steam.
6. Press the steam trigger with a little force, the steam will be sprayed from the soleplate
continuously, and then you can iron the garment with steam.
7. Quickly press the steam trigger twice to produce shot of steam if you need to remove hard
crease.
Note: There may be dripping water during spraying steam when the temperature of the
soleplate is at and lower than the second setting. This is normal.
Caution:
1) Do not touch hot soleplate at any time before cooling down!
2) Never direct the steam at people!
3) Do not activate the steam trigger when the iron is placed on the unit base to avoid being
scalded by steam.
8. After ironing, press down the power button for more than 2 seconds, the appliance will be
turned off and all the indicators will extinguish. Remove the plug from the wall socket. But
the soleplate is still hot, never touch it with hand, place it on the thermal insulation stand
until it cools down completely.
Publicidad
