Publicidad
Idiomas disponibles
Idiomas disponibles
Filling aperture
Fill the water tank with water through the filling aperture of water tank. Make sure that the
water shall not exceed the MAX mark of water tank.
Power button
Plug in the appliance and press down the power button, the power indicator will illuminate,
the low steam rate is regarded as defaulted one and its indicator will blink. Hold and press
the power button for more than 2 seconds, the appliance will be cut off.
Steam rate control button
The steam rate can be selected low, medium or high by the steam rate control button. Any
one to be selected, its indicator will blink, and it will illuminate solidly after finish
preheating, which means that the steam is ready for use. The indicator of selected steam rate
will blink when the steam rate is switched from low setting to high setting, while it will
illuminate solidly when the steam rate is switched from high setting to low setting.
Temperature dial
Turn the dial to set ironing temperature based on the garment needs to be ironed.
Temperature indicator
The appliance will heat up when it has not reached the selected temperature. The temperature
indicator will illuminate when the appliance is heating up. Once the appliance has reached
the selected temperature, the temperature indicator will extinguish. The temperature indicator
will be cycled on and off as the iron maintains the selected temperature during ironing.
Iron lock
Put the iron on the thermal insulation stand of unit base, then push the iron lock to " "
position to lock the iron on the unit base. To unlock, push the iron lock to "
" position, then
you can remove the iron to iron the clothes (see Fig.1). The whole steam station can be lifted
up by grasping the iron' s handle after the iron being properly locked on the unit base (see
Publicidad
