Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
11
Making the water supply
connections
NOTE: The hot side inlet tube is indicated by a label.
If the label is not present, the hot supply tube is the longer
of the two inlet tubes.
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
NOTE: Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube fitting.
This will prevent the supply tube from moving or twisting
when tightening the faucet connector. Do not overtighten.
Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator from the faucet (A) with a coin (1) to flush the water
lines.
□
Turn on the water supply to check for leaks.
If you discover any leaks, check your connections
to ensure they are installed properly.
□
Turn the water on by activating the sensor (2)
by keeping your hand within 4 inches of the
sensor and allow both hot and cold water to
run for at least one minute each. This flushes
away any debris that could cause damage to
internal parts.
□
Turn off the water and reinstall the aerator.
1
3
0
1
min.
45
15
30
1
11
Please contact 1-855-HD-GLACIER for further assistance.
2
2
HOMEDEPOT.COM
A
Publicidad
