Descargar Imprimir esta página

Glacier bay HD67688W-6001 Instrucciones De Montaje página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Shut off the water supply. Remove the old
faucet.
Clean the mounting surface.
Remove the preassembled nut (E) and
washers (C & D) from the new faucet (A).
WITH NO DECK PLATE:
body (A)-including inlet tubes, hose (1) and sensor
cable (2)-through the hole in the sink.
WITH DECK PLATE:
gasket (G) and deck plate (F) with the mounting
holes in the sink. Install the faucet body (A)-
including inlet tubes, hose (1) and sensor cable
(2)-through the middle hole in the deck plate (F).
NOTE: Silicone sealant is required under the gasket (G).
Install the faucet
A
2
1
Align the holes in the
A
F
G
2
1
2
Securing the faucet assembly
Loosen the screws (O) on the nut (E) until the
ends of the screws (O) are flush with the face
of the nut (E).
Install the washers (C & D) onto the threaded
mounting shank. Thread the nut (E) onto the
mounting shank. Lock the nut (E) into position
by tightening the screws (O). Do not
overtighten.
C
D
E
4
1
O
E
O

Publicidad

loading

Este manual también es adecuado para:

Hd67688w-6010hHd67688w-6004Hd67688w-604405311893464311893465317147255 ... Mostrar todo