Publicidad
Idiomas disponibles
Idiomas disponibles
BM 1619X00889 3-05
DEPTH ADJUSTMENT
Your saw is equipped with a depth detent
system that will stop the foot at 2x, 3/4", 1/2",
and 1/4" standard lumber depths.
Disconnect plug from power source. Loosen
the depth adjustment lever located in the
housing of saw. Hold the foot down with one
hand and raise or lower saw by the handle.
FIG. 3
CALIBRATED
DEPTH BRACKET
ADJUSTABLE
DEPTH LEVER
2
1
FOOT
90° CUTTING ANGLE CHECK
Disconnect plug from power source. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set to 0° on quadrant,
retighten lever and check for 90° angle
between the blade and bottom plane of foot
with a square (Fig. 5). Make adjustments by
turning the small alignment screw from bottom
side of foot, if necessary.
BEVEL ADJUSTMENT
Your saw is equipped with a bevel detent
system that will stop the foot at 22.5°, and 45°
angles.
Disconnect plug from power source. The foot
can be adjusted up to 56° by loosening the
bevel adjustment lever at the front of the saw.
Align to desired angle on calibrated quadrant.
Then tighten bevel adjustment lever (Fig. 6).
Your saw also features a adjustable bevel
adjustment lever for consistent locking. To
adjust, simply pull outward on lever and
reposition to desired position (Fig. 1).
Because of the increased amount of blade
engagement in the work and decreased
3/20/05
10:01 PM
Operating Instructions
Page 10
Tighten lever at the depth setting desired.
Check desired depth (Fig. 3).
Your saw also features a adjustable depth
adjustment lever for consistent locking. To
adjust, simply pull outward on lever and
reposition to desired position (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
FIG. 5
FOOT
BLADE
90°
stability of the foot, blade binding may occur.
Keep the saw steady and the foot firmly on the
workpiece.
FIG. 6
-10-
FIG. 4
BEVEL
ADJUSTMENT
LEVER
ALIGNMENT
SCREW
QUADRANT
BEVEL
ADJUSTMENT
LEVER
Publicidad
