Descargar Imprimir esta página

Fanimation LEVON MAD7912B Serie Manual página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
1. To set the code on receiver unit, slide dip switches to
the same positions as set on the remote. (Figure 1)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from or to
other remote units, simply change the combination code
in the remote and receiver.
NOTE: Factory setting is all up. Do not use this position.
WARNING
To avoid possible electrical shock, be sure electricity
s i
u t
n r
e
d
o
f f
t a
h t
e
m
a
(Figure 2).
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION COULD
DAMAGE THIS RECEIVER.
2. Slide the receiver into the hanger bracket as shown in
Figure 3.
3. Connect wires using connectors as shown in Figure 4.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors. Do not operate fan until the blades are in
place. Noise and motor damage could result.
4. After connections have been made, slide the receiver
into the hanger bracket, taking care not to pinch the
wires and put the white and green leads to one side and
the black leads towards the other side. The wires should
be spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the outlet
box and the ungrounded conductor on the other side.
(Figure 5)
How to Wire Your Ceiling Fan
n i
u f
s
e
b
o
x
b
e
o f
e r
w
r i
n i
WARNING
ON
1
g
Hanger Bracket
Receiver
L
N
AC POWER
GREEN-Ground Wire
From Ceiling
GREEN-Ground Wire
From Hanger Bracket
GREEN-Ground Wire
From Hanger Ball
GREEN / YELLOW
- Ground Wire (2)
From Receiver
GRAY
YELLOW
10
Receiver Unit
Dip Switch
2
3
4
5
Figure 1
Figure 2
Figure 3
BLACK
WHITE
GROUND
HANGER
YELLOW
BRACKET
/ GREEN
HANGER
BALL
Receiver
Figure 4
RECEIVER HARDWARE USED:
WIRE
CONNECTORS
RED
Figure 5
MAIN FUSE BOX
NOTE: Supply wires
omitted for clarity
BLUE
BLACK
/ WHITE
RED
GRAY
YELLOW
DC MOTOR
BLACK
ANTENNA
x 8
LISTED
OUTLET
BOX
WHITE
BLACK
BLUE
BLACK & WHITE

Publicidad

loading