Sharp UA-HG50E Manual De Uso página 16

CARE AND MAINTENANCE
FILTER INDICATOR
The fi lter reset Indicator light will turn on after approximately
720 hours operating. (30 days × 24 hours =720 hours)
This is a reminder to perform the maintenance described be-
low. After performing maintenance, reset the Filter Indicator.
CARE INDEX
1
2
4
Place
1 Water Tank
2 Unit / Back Panel (Pre Filter)
3 Sensors
Humidifying Filter
4
Humidifying Tray
HEPA Filter
5
Deodorizing Filter
RESET
more than
3 sec.
3
5
2
Ref.
E-13
E-14
E-15
E-13
WATER TANK
Rinse the inside
with water.
NOTE
How to clean hard to remove dirt.
Tank Cap
Toothbrush
UNIT / BACK PANEL
Wipe with a dry, soft cloth.
Sensors
Back Panel
(Pre Filter)
Remove the dust gently with
a cleaning tool such as a vac-
uum cleaner.
NOTE
How to clean hard to remove dirt.
Back Panel
1. Add a small amount of kitchen
detergent to water and soak for
about 10 minutes.
CAUTION
Do not apply excessive pressure
when scrubbing the back panel.
2. Rinse off the kitchen detergent with
clean water.
3. Completely dry the fi lter in a well
ventilated area.
Sensor Filter
Sensor Filter
1. Remove the Back Panel.
2. Remove the sensor fi lter.
3. If the sensor fi lter is very dirty, wash
it with water and dry it thoroughly.
Clean the inside of
the Water Tank with
a soft sponge and
the Tank Cap with
a cotton swab or
toothbrush.