IPC PW-H25 Universe Manual De Instrucciones página 20

USING
THE CLEANER
CONTROL PANEL
A - On/off switch
B - Temperature regulator
C - Detergent control tap. (if
available).
D - Pressure gauge. (if avai-
lable).
STARTING THE CLEANER
1) Turn on the water supply tap (fig. 5A).
2) Connect the water cleaner to the mains electricity supply via
the omnipolar switch or by plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to pos. 1
(fig. 7A).
The high pressure water jet generates a reaction force in the
lance. Keep a firm grip on the lance handle.
4) Press the trigger on the gun and begin washing.
5) To use the cleaner with hot water, turn the temperature regu-
lator (fig. 7B) to the recommended washing values.
For some models turn the ignition switch (fig. 7A) onto the
hot water position before effecting the operations described
in this point.
In water cleaners with the "Total Stop" system, the motor
!
starts and stops when the lever on the lance handle is actioned
or released.
Do not block the handle lever in the delivery position.
!
IMPORTANT!
To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfunc-
tion (Fig. 8).
English
STOPPING THE CLEANER
1) Switch off the burner by
turning the pressure regulator
to pos. "0" (fig. 7B).
2) Let the cleaner run with
cold water only for at least
30 seconds to cool down the
boiler.
3) After using with detergent,
flush out the intake circuit;
place the detergent suction
FIG. 7
hose (fig. 9) in a tank of clean
water and let the pump run
for 1 minute with the dosing
tap turned fully on and the
lance in detergent delivery
condition.
4) Stop the cleaner by turning
the selector switch to pos. "0"
(fig. 7A).
5) Discharge the pressure
from the H.P. hose by pressing
the trigger on the gun
6)
Disconnect the water clea-
ner from the mains electricity
supply via the omnipolar
switch or by unplugging the
plug from the socket.
7) Turn off the water supply
tap (fig. 5A).
If the water cleaner is left,
!
even temporarily, turn it off by
using the omnipolar switch or
by unplugging the plug from
the socket.
!
Water cleaners with the
"Total Stop" device should
be considered as off when
the omnipolar switch is in
the "O" position or the plug is
unplugged from the socket.
When the water cleaner
!
is not used, close the safety
device on the handle.(fig.11)
!
Dry use of the water
cleaner causes serious dam-
age to pump gaskets.
FIG. 8
- 20 -
FIG. 9
FIG. 10
USE OF THE DOUBLE LAN-
CE (fig. 10)
The double lance allows the
operator to select a low or high
pressure jet. The pressure is
selected with the gun in pos.
1. High pressure: pos. 2. Low
pressure pos. 3.
FIG.11