Fanimation HENRY FP8519BL Manual Del Usuario página 11

NOTE: This step is applicable after the neccessary
wiring is completed.
Remove one of the two shoulder screws in the
1.
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
To Reduce The Risk Of Electric Shock, Disconnect
The Electrical Supply Circuit To The Fan Before
Installing Light Kit.
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later. Slightly loosen the
remaining two screws. (Figure 1)
2. Assemble the light kit to the motor assembly
support bracket using the two key slots in the
light kit. Replace the previously removed screw and
securely tighten all three screws. (Figure 2)
How to Install Your Canopy Housing
WARNING
How to Assemble Your Light Kit and Glass
CAUTION
Motor
Assembly
Light Kit
11
Ceiling
Canopy
Figure 1
Canopy Screw
Figure 2
Cover
Figure 1
Figure 2