Fanimation GLIDEAIRE FPD8520B Manual Del Usuario página 13

1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
Do not operate this fan with a variable (Rheostat)
wall controller or dimmer switch. Doing so could
result in damage to the ceiling fan's remote control
unit.
3. To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting process.
If not used for long periods of time, remove battery to
prevent damage to transmitter. Store the remote away
from excessive heat or humidly. (Figure 3)
4. To set the remote code with a small screwdriver or
ball point pen (neither included), slide dip switches
firmly up or down. (Figure 4)
NOTE: Factory setting is all up. Do not use this
position.
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
How to Operate Your Ceiling Fan
WARNING
WARNING
For illustrative purposes only-not
intended to cover all types of controls
3V CR2032
Battery (2 pcs)
Remote
Dip Switch
13
Figure 1
MAIN FUSE BOX
Figure 2
Figure 3
Figure 4