Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 67 Tuesday, January 31, 2023 5:37 PM
A:
Do not cover racks with aluminum foil. Covering entire racks with foil restricts air flow, leading to
poor cooking results. Use a sheet pan lined with foil under fruit pies or other acidic or sugary foods to
prevent spillovers from damaging the oven finish.
CAUTION
• Foil may be used to wrap food in the oven, but do not allow the foil to come into contact with the
exposed heating/broiling elements in the oven. The foil could melt or ignite, causing smoke, fire, or
injury.
Q:
Can I leave my racks in the oven when running a Self Clean cycle?
A:
No. Although it will not damage the racks, it will discolor them and may make them hard to slide in
and out during use. Remove all items from the oven before starting a Self Clean cycle.
Q:
What should I do if my racks are sticky and have become hard to slide in and out?
A:
Over time, the racks may become hard to slide in and out. Apply a small amount of olive oil to the
sides of the racks. This will work as a lubricant for easier gliding.
Q:
Why aren't the function buttons working?
A:
Make sure that the appliance is not in Control Lock mode. The lock
Control Lock is activated. To deactivate Control Lock, refer to the Control Lock Feature section. The
unlock melody sounds and
Q:
My appliance is still dirty after running the EasyClean cycle. What else should I do?
A:
The EasyClean cycle only helps to loosen light soils in your appliance to assist in hand-cleaning of
your oven. It does not automatically remove all soils after the cycle. Some scrubbing of your
appliance is required after running the EasyClean cycle.
Q:
I tried scrubbing my oven after running EasyClean, but some soils still remain. What can I do?
A:
The EasyClean feature works best when the soils are fully soaked and submerged in water before
running the cycle and during hand-cleaning. If soils are not sufficiently soaked in water, it can
negatively affect the cleaning performance. Repeat the EasyClean process using sufficient water.
Sugar-based and certain greasy soils are especially hard to clean. If some stubborn soils remain, use
the Self Clean feature to thoroughly clean your oven.
Q:
Soils on my oven walls are not coming off. How can I get the oven walls clean?
A:
Soils on the side and rear walls of your appliance may be more difficult to fully soak with water. Try
repeating the EasyClean process with more than the ¼ cup (2 oz or 60 ml) of spray recommended.
Q:
Will EasyClean get all of the soils and stains out completely?
A:
It depends on the soil type. Sugar-based and certain grease stains are especially hard to clean. Also, if
stains are not sufficiently soaked in water, this can negatively affect cleaning performance.
If stubborn or built-up stains remain, use the Self Clean feature. Refer to the Self Clean section of
your owner's manual.
Q:
Are there any tricks to getting some of the stubborn soils out?
A:
Scraping the soils with a plastic scraper before and during hand-cleaning is recommended. Fully
saturating soils with water is also recommended.
However, certain types of soils are harder to clean than others. For these stubborn soils, the Self
Clean cycle is recommended. Consult the Self Clean section of your owner's manual for details.
Q:
Is it safe for my convection fan or heater element to get wet during EasyClean?
A:
Yes. The convection fan or heater element may get a little wet during cleaning. However, direct spray
onto the broil burner and heater elements is not necessary because these are self-cleaning during
regular use.
appears in the display until the controls are unlocked.
Loc
TROUBLESHOOTING
will show in the display if
k
67
Publicidad
