Operating Your Compressor Nebuliser - HS AirMed 1000 Instrucciones De Uso

en
4
4.
Note: Prior to initial operation, the nebuliser should be thoroughly cleaned.
1. Place your Compressor Nebuliser on a flat and stable surface. Be sure that
you can easily reach the controls when you are seated.
Important: Prior to initial operation, the nebuliser should be thoroughly
cleaned referring to 'Cleaning', section 7, page 6 in the handbook.
2. Gently twist the top part of the nebuliser counter-clockwise to disassemble
the nebuliser.
3. Fill the bottom section of the nebuliser with the
medication prescribed by your physician. Be
sure that the cone is put inside the bottom section.
4. Gently twist the top part clockwise to re-assemble
the nebuliser. Be sure the two sections fit well.
5. Attach one end of air tube to the base of the nebuliser.
6. Attach the other end of air tube to the air tube connector located on the
front of the compressor.
7. Attach mouthpiece or mask per your choice to the top section of nebuliser.
8. Plug the mains lead into an appropriate electrical outlet. Make sure at this
stage, the power switch is at "OFF" status.
9. Press power switch to begin your prescribed treatment.
Important: The compressor motor has a thermal protector which will shut
the unit off before the unit is overheated.
When the thermal protector shuts the unit off, please:
a. Switch the unit off.
b. Unplug the unit from the electrical outlet.
c. Wait 30 minutes for the motor to cool down before another treatment.
10. When treatment is finished, switch the unit off and unplug it from the
electrical outlet.
Please Note:
The device should be positioned so that the mains plug is easily accessible to
disconnect the device.

Operating Your Compressor Nebuliser

Make sure the air openings are not obstructed.
Place cone
inside and
fill with
medication