rpan
- Pan Reverse
With this function you can reverse the Pan-movement.
• Select "RPAN" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
rtil
- Tilt Reverse
With this function you can reverse the Tilt-movement.
• Select "RTIL" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Switch 16 bit/8 bit
With this function you can switch the device from 16 bit to 8 bit resolution.
• Select "16BI" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] or [DN] to select "ON" in order to set 16 bit, or "OFF" in order to set 8 bit. The channels
PAN Fine and TILT Fine will be disabled.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Mic sensitivity
With this function, you can select the desired microphone sensitivity between 0 % and 99 %.
• Select "MIC" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm; the display shows "M-70".
• Press [UP] to select the desired sensitivity.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Auto run if no DMX
With this function, you can set the device to auto run if no DMX-signal.
• Select "AUTO" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Music control if no DMX
With this function, you can set the device to sound-controlled program-run if no DMX-signal.
• Select "SOUN" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
Rest
- Reset
With this function you can Reset the device via the Control Board.
• Select "REST" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
47/102
51839925_V_1_3.DOC