Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Dishwasher chimes if
panel is touched during
operation.
Dishwasher did not finish
cycle.
Leaking in front of unit
P1, P2, P3, or P4 appears
in display.
n:#, U:#, d:#, t#
appearsin display.
(# = a number)
L0, L1, L2, L3 or L4
appears in display.
CL appears in display.
Bumping into or touching the control panel during operation may result in
a disabled button sound. Only the Power, Start, and Control Lock buttons
are enabled during operation to prevent cycle settings from being changed
inadvertently.
• Button sounds can be turned off by pressing and holding Half Load for three
seconds.
• The end of cycle chime and safety alert sounds will still sound.
Door was opened during cycle.
• If the door is opened during a cycle, the Start key must be pressed within 4 minutes
or the machine turns off and all settings are lost.
Dishwasher not leveled properly.
• Verify the unit is level from side to side and from front to back. See leveling
instructions in the Installation section.
Wrong detergent used.
• If excessive sudsing is causing the leak, allow the foam to subside for 24 hours
then clean the inside of the tub with milk.
The Download cycle is selected.
• This is not an error code. This code indicates the current Download cycle.
Test mode is selected.
• This is not an error code. This code is used when testing the dishwasher. Power the
unit off and on and the code
Rinse Aid Level setting mode is selected.
• This is not an error code. This code indicates the current rinse aid level.
information, refer to the Adding Cleaning Agents section.
Control Lock is activated.
• This is not an error code. This code indicates that the control lock is activated. Press
and hold Half Load and Energy Saver simultaneously for three seconds.
Possible Cause & Solution
will disappear.
TROUBLESHOOTING
For more
51
Publicidad
