SOMFY TLW25 WT Instrucciones página 21

TLW25 WT
2.4. TIPS AND ADVICES ON OPERATION
2.4.1. Questions about the product ?
Observations
The blind does not move.
The motor runs in
the opposite direction.
After an Up order, the
motorised product
performs a short jerky
movement from the down
position and continues to
rise normally.
3. TECHNICAL DATA
Power Supply
Operating temperature
Torque depending on the motorisation
Restrictions
Protection rating
Maximum number of slat tilting
For additional information on the technical data for this drive contact your Somfy representative.
SOMFY ACTIVITES SA, F-74300 CLUSES as manufacturer hereby declares that
the drive covered by these instructions and used as intended according to these
instructions is in compliance with the essential requirements of the applicable
European Directives and in particular of the Machinery Directive 2006/42/EC, and
the EMC Directive 2014/30/EU.
The full text of the EU declaration of conformity is available at www.somfy.com/ce.
Philippe Geoffroy, Approval manager, acting on behalf of Activity director, Cluses,
11/2020
©
Copyright 2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
Possible causes
The motor is
disconnected.
The wiring is incorrect.
Up end limit is not set.
24 V DC
-10°C / 85°C (14°F / 185°F)
0.6 N∙m / 0.8 N∙m / 1.2 N∙m
-10°C / 0°C (14°F / 32°F): 100 cycles
60°C / 75°C (140°F - 167°F): 2,000 cycles
75°C / 85°C (167°F - 185°F): 500 cycles
IP 20
20 000
Solutions
- Check the power supply to the
motor.
- Check the motor wiring.
Reverse the wires + and - if necessary.
Complete full sequence described in
chapter 2.3.1. Setting the up end limit
position without TL 25 WT Setting tool.
EN
21