Automatic Charging - SOLAC ECOGENIC Instrucciones De Uso

)
Run the charging station's power cord alongside the wall, otherwise the robot could get
entangled in it.
4 Press the control button
control panel. The robot vacuum will search for the charging station, if it is within a
suitable distance, and connect to it.
5 If you want to cancel the charging command during the search, press the control button
or remote control button
)
Check that the robot connectors (26) connect properly with the charging station's
connectors (6A).
,
Whilst charging, the charging indicator lights of the charging station (5A) and control
panel will flash. Once charging is complete, the charging indicator lights of the
charging station (5A) and the control panel
appliance is ready for use.
,
Do not turn off the charging station while vacuuming, as the robot vacuum will return to
it for charging, if its battery charge level drops too low.
If you like, you may put a small amount of the scent of your choice in the centre of the
decorative LED (1A).
6 Press the switch (2A).
,
The LED (1A) will light up. When it heats up, the fragrance of the scent inside the LED
will spread.
)
Some scents can damage the plastic surface. Check that the scent will not damage the
surface before use.
CHARGING WITHOUT THE CHARGING STATION (Fig. 2)
1 Connect the adaptor cable directly to the connector (19) of the robot vacuum's body
(11).
2 Plug the adaptor into the mains.
,
The LED indicator light on the robot's control panel
will stop flashing when charging is complete.
,
The robot cannot be started up while it is being directly charged using the power cord.
3 After charging, unplug the adaptor from the mains and then disconnect the cable from
the connector (19). The appliance is ready for use.
)
The adaptor heats up slightly while charging. This is normal, unless it becomes very hot.

AUTOMATIC CHARGING

,
During cleaning, the robot will always automatically seek the charging station
when its battery charge is low.
)
After cleaning, the battery temperature may be high and therefore the charge time may
be longer.
Tips to Extend Battery Life
• Do not leave the adaptor connected for long periods of time. Disconnect it when it has
finished charging.
• Do not store or charge the appliance near radiators or other heat sources, or exposed
to direct sunlight.
• Do not charge the appliance in dirty or damp places. The room temperature should be
between 15ºC and 35ºC.
• Every few months, allow the batteries to drain completely and then recharge them. To
discharge them, use the appliance in cordless mode until it stops, with the charging
station switched off. Then, recharge the batteries as explained above.
PREPARING THE APPLIANCE CHARGING THE ROBOT VACUUM
of the remote control or the
again. The robot vacuum will stop.
will stop flashing and remain lit. The
button on the robot's
will flash while charging and
en
19