Stihl FSA 90 R Manual De Instrucciones página 10

English
To reduce the risk of electric shock:
Always connect the unit to a
–
properly installed wall outlet.
Make sure the insulation of the
–
power supply cord and plug is in
good condition.
Unplug the power supply cord from the
outlet when charger is not in use.
Do not open or dissassemble charger –
there are no user serviceable parts
inside.
Never store a battery in the charger.
Store charger out of the reach of
children.
THE USE OF THE POWER TOOL
Transporting the Unit
WARNING
To reduce the risk of injury from loss of
control and line contact, never carry or
transport your power tool with the cutting
attachment moving.
WARNING
Always switch off the power tool, move
retaining latch to ƒ and remove the
battery – even when you carry the unit
for short distances. When transporting it
in a vehicle, properly secure the power
tool to prevent turnover and damage.
Remove the battery from
the power tool. This
avoids the risk of the
motor starting
unintentionally.
8
It may be carried only in a horizontal
position. Grip the shaft in a manner that
the machine is balanced horizontally.
Keep the cutting attachment behind you.
Before Starting Work
WARNING
Always check your power tool for proper
condition and operation before starting,
particularly the trigger switch, trigger
switch lockout and retaining latch. With
retaining latch on ‚ , the trigger switch
and the trigger switch lockout must
move freely and always spring back to
the idle position. Never attempt to
modify the controls or safety devices.
WARNING
Never operate your power tool if it is
damaged, improperly adjusted or
maintained, or not completely or
securely assembled.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, grease
or resin in order for you to maintain a firm
grip and properly control your power
tool.
WARNING
To reduce the risk
of personal injury
to the operator
from line contact
and thrown
objects, make sure
your unit is
equipped with the
proper deflector
and handle for the
type of cutting
attachment being
used (see chapter
on "Approved
Combinations of
Cutting Attach-
ment, Deflector,
Handle and
Harness").
Keep the deflector adjusted properly at
all times (see chapter on "Mounting the
Deflector" of your instruction manual.)
Adjust the hand grip to suit your size
before starting work. The machine
should be properly balanced for proper
control and less fatigue in operation.
WARNING
The cutting attachment must be properly
tightened and in safe operating
condition. Inspect for loose parts (nuts,
screws, etc.). Regularly check the
condition and tightness of the cutting
attachment – with the motor stopped,
retaining latch on ƒ and battery
removed! Replace damaged cutting
attachments before using the power
tool.
FSA 90 R