SEVERIN FKS 8839 Instrucciones De Uso página 14

Familiarisation
1. On/Off switch for interior light
2. Temperature control
3. Temperature indicator
4. Mains indicator light
5. LED interior lighting
6. Fan
7. Storage racks
8. Drain channel cleaning tool
9. Condensor
10. Compressor with mains power plug
11. Door lock with set of keys
Before using for the first time
∙ Remove any exterior and interior packaging materials.
∙ Please ensure proper disposal of all packaging
materials.
∙ Fit the two spacer elements (1), provided, into the
corresponding guide slots (2) on the rear.
∙ Remove the red transport securing device (A); this is for
transport purposes only and can be disposed of.
14
∙ Clean the appliance as described under Cleaning and
defrosting.
∙ For positioning, we recommend that you tilt the unit
slightly backwards. In this way, the transport rollers can
be used to move it to its intended place of installation.
∙ The unit should only be transported in its vertical
position; do not tilt any more than 30°.
∙ Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
∙ If the unit has been tilted more than 30° during transport,
allow it to stand upright for at least 4 hours before it is
connected to the mains.
∙ When the unit is first switched on, a slight 'new' smell
may be noticed. However, this will disappear once the
cooling process has begun.
Installation
∙ The appliance should be set up in a well-ventilated, dry
room.
∙ It should be operated in conditions where the relative
humidity is no more than 60 %.
∙ The product data sheet contains details of the ambient
temperature range suitable for this appliance.
∙ Do not use the appliance outdoors.
∙ Ensure that the plug is accessible and can be removed from
the wall socket at any time.
∙ Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers
etc). If this cannot be avoided, however, suitable insulation
must be in installed between the heat source and the unit.
∙ The unit must not be installed inside a cabinet, nor directly
below a hanging cupboard, shelf or similar object.
∙ If the unit is installed next to a wall, a minimum lateral
distance of 10 mm is necessary for the door to fully open.
∙ If the floor is uneven, the adjustable feet on the unit can be
used to compensate and ensure optimum stability.