Heater Operating Instructions
1) Press the MODE key until the word Heat is
displayed in the LCD window. Fig. 20. Each
depression of the MODE key will advance to a
different mode setting (Cool-Dry-Heat-Fan). The
red indicator light will come on indicating the
"Heating" mode is operational (there may be a
slight delay of 5-10 seconds before the cycle
begins, this is normal).
2) Press the appropriate
to select a suitable temperature between
17°C (63°F) to 30°C (88°F). Fig. 21.
3) Press the FAN key to select the desired fan
speed setting (High-Low). Your selection will be
displayed in the LCD window. Each depression
of the fan key will alternate between the different
fan speed settings. Fig. 22.
4) Press the SWING key to activate the automatic
air swing (oscillating) feature, (the "air swing"
symbol will appear in the LCD window). Fig. 23.
To deactivate the air swing feature, press the
SWING key again.
5) To adjust "air flow" direction, (up / down only)
adjust any one of the Horizontal Louver Blades
(excluding the top or bottom louver) and the
remaining louvers will automatically adjust to the
same position. Fig. 24.
Heating stops automatically when the room
temperature reaches the desired setting. The "red"
indicator mode light will close. Heating will resume
when the room temperature falls below the
established temperature setting.
or
key
Water Full
Cool/Heat/Dry
Water Full
Cool/Heat/Dry
Water Full
Cool/Heat/Dry
TIMER
Water Full
MODE
FAN SPEED
Cool/Heat/Dry
Red Light
12:00
TIMER
TIMER
ON
MODE
HEAT
FAN SPEED
HIGH
25¡c
TEMP.
Temperature
12:00
TIMER
ON
MODE
HEAT
FAN SPEED
HIGH
25¡c
TEMP.
Fan Speed
12:00
TIMER
ON
MODE
HEAT
FAN SPEED
HIGH
25¡c
SWING
TEMP.
Air Swing
13
I/O
12:00
ON
HEAT
FAN
HIGH
SWING
00
TEMP.
Heat Mode
I/O
MODE
FAN
ON
TIMER
OFF
SWING
I/O
MODE
FAN
ON
TIMER
SWING
OFF
I/O
MODE
FAN
ON
TIMER
OFF
SWING
MODE
TEMP./CLOCK
ADJ.
ON
TIMER
OFF
CLOCK
Fig. 20
TEMP./CLOCK
ADJ.
CLOCK
Fig. 21
TEMP./CLOCK
ADJ.
CLOCK
Fig. 22
TEMP./CLOCK
ADJ.
CLOCK
Fig. 23
Fig. 24