Publicidad
Idiomas disponibles
Idiomas disponibles
English
6
TECHNICAL INFORMATION
1.-
KNOB
2.-
SCREW FIXATION
3.-
COVERS SCREW
4.- ROSETTE
5.- CARTRIDGE
6.-
BODY
7.- BALL-AND-SOCKET JOINT
8.- AERATOR
Thank you for choosing Gala products. It is our objective that this fitting always provides full satisfaction.
Gala fittings are subject to meticulous quality control during the entire manufacturing process, providing customers with a quality product
that meets their day-to-day requirements.
WARRANTY
Gala guarantees the correct operation of this fitting for 5 YEARS, from the date of purchase, against any manufacturing defects, visible
or not, as long as the assembly, use and service, are in accordance with the handling and use instructions.
Any defective fitting must be sent, postage paid, to Gala for examination, together with the proof of purchase to validate the process.
The warranty does not cover labour charges, call-out fees or indemnification.
THE WARRANTY IS NOT APPLICABLE IN THE FOLLOWING CASES
- Incorrect installation and/or servicing;
- Accidents or incorrect handling;
- Damage caused by low water quality (sand, limescale, etc.);
- Normal wear of parts and consumables (seals, valves);
- The use of abrasive or corrosive products on the fitting surface (solvents, strippers and acids, including whitening toothpastes);
- Damage on surface coating caused by removal of an installed fitting.
CLEANING RECOMMENDATIONS
- Clean only with specific products for chrome-plated surfaces (without acids and solvents) using a soft cloth. The fitting may also be cleaned
using lightly soaped water and a damp cloth, then rinsing the fitting thoroughly with clean water and drying it with a soft cloth or towel;
- To prevent limescale stains, clean the tap after each use;
- The maintenance of the aerator must be performed with a liquid limescale-removing product (fig. 8).
PRESSURE
- Maximum working pressure: 6 bar;
- Recommended working pressure: 3 bar; If working pressure is above the recommended value, a pressure reducer should be installed;
- Minimum working pressure: 0.5 bar (0.8 for bathtub mixer);
- Caudal at 3 bar: 20 litres/minute;
TEMPERATURE
- Maximum temperature: 75ºC;
- Recommended maximum working temperature: up to 40ºC.
GRECIA
9 .- SEAL
10.- FLANGE RING
11.- FLANGE
12.- THREADED PIN
13.- STAY
14.- SUPPLY TUBES
15.- CLAMP
16.- HORIZONTAL ROD
17.- VERTICAL ROD
18.- DRAIN BODY
19.- SEAL
20.- SEAL
21.- DRAIN
22.- CAP
Publicidad
