Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
8.
Remove cabinet screw and door plug from opposite side and insert
into the holes previously used by the door.
9.
Remove the door pin from the lower hinge bracket by turning it
counterclockwise, then reinsert it into the neighboring treaded
hole and tighten.
10. Align the door with the cabinet first. Then install the lower hinge
bracket to the bottom opposite side of the cabinet. Make sure
door is resting on door pin of the lower bracket. Then insert (2)
remaining screws into the holes. Tighten the screws.
11.
Align top hinge bracket with screw holes, insert screws and
partially secure, check that door and cabinet are properly aligned
and then secure tightly.
NOTE:
If the top of the door is not aligned with the cabinet, loosen the top
hinge screws, adjust door and re-tighten the screws.
12. Replace the Top Hinge Cover and Leveling Leg. Make sure Leveling
Leg is installed to the opposite side of the door hinge. Adjust Leg
as necessary.
Page 12
Publicidad
