HIKOKI WR 14DBDL2 Instrucciones De Uso página 6

English
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
WR14DBDL2 / WR18DBDL2
: Cordless Impact Wrench
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
Direct current
V Rated voltage
n
No-load speed
0
min Oscillation per minute
-1
Bpm Impact rate
Ordinary bolt
H
High tension bolt
Hm High mode
Mm Medium mode
Lm Low mode
Sm Single mode
MT Tightening torque (Maximum)
Square drive size
Weight *
(According to EPTA-Procedure 01/2014)
kg
Switching ON
Switching OFF
Disconnect the battery
Light section switch
ON
Always ON (turn off after 2 minute)
ON
OFF
ON
Light only SW-ON
ON
OFF
ON
Always OFF
ON
OFF
Clockwise rotation
Counterclockwise rotation
Battery capacity
Remaining battery indicator switch
The battery remaining power is nearly empty.
Recharge the battery soonest possible
The battery remaining power is a half.
The battery remaining power is enough.
Lights ;
The battery remaining power is over 75%.
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%.
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
Tightening mode selector switch
Tightening mode indicator lamp
Low mode
"Light load work"
Installing pipe supports, scaff olding, etc.
Medium mode
"Light load work"
Installing pipe supports, scaff olding, etc.
High mode
"Heavy load work"
Assembling steel frames, etc.
Single mode
"Delicate work"
Tightening small diameter screws (M6 or
similar), etc.
Warning
* Depending on attached battery. The heaviest weight is
measured with –
– BSL1450 for [WR14DBDL2]
– BSL36B18 (sold separately) for [WR18DBDL2]
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 246.
Standard accessories are subject to change without notice.
6