Vitrifrigo OCX IM XT Manual De Instrucciones página 22

Once at the correct temperature, the thermostat will close,
1
enabling the heating element and the motor.
The extractor blades will press on the ice until it detaches;
2
The blades extract the ice cubes from their seating, pouring
3
The ice production cycle continues until the ice tray has been filled or until the
water in the tank has been used.
Maintenance mode
During maintenance operations, the ice-making operations are interrupted.
At this stage, the thermostat must be turned to the "ice maintaining" position.
This thermostat setting keeps the ice cubes in optimum condition, even for long periods.
During the maintenance stage, the thermostat is set to prevent the formation of a layer
of ice on the front section of the tray or on the front of the grid assembly, as well as
reducing ice maker power consumption.
The machine enters maintenance mode when:
• There is no water (REFILL version). Refill the tank to reset the machine to ice-making
mode.
• The tray is full of ice. Empty the tray (even partly), to rest the machine to ice-making
mode.
ATTENTION Check the water level of the machine on a regular basis, using the indicator,
and pour in more water if necessary.
Insufficient water will lead to the production of ice being suspended or to the production
of irregular-shaped cubes, and may even cause damage to the pump.
ENG
22
the heating element remains enabled.
them into the tray.
EJECTION