Skotti-grill SKOTTI Manual De Instrucciones página 14

5.3 Fill the grease drip tray with water.
!
BEFORE USING WITH GRILL CHARCOAL OR WOOD: SPREAD DRY SAND
EVENLY 1 CM HIGH IN THE BOTTOM TRAY!
5.4 Placing of the grill grate
To place the grill grate, proceed as follows:
1. Place Skotti in front of you, with the round end of the
burner pipe (3) pointing to the right.
2. Take the grill rack (1) with the Skotti logo on the bot-
tom right.
3. Insert the grill rack (1) into the corresponding slots on
the right side.
4. Let the rack (1) slide into the slots on the left side.
5. Carefully pull the grill rack (1) back at the tabs, to-
wards the right.
✔
and stable.
5.5 Grilling with charcoal or wood
Possible risk of fire due to incorrect use.
▶ Never use the burner pipe to ignite charcoal or wood.
▶ Never put Skotti on the carrier bag when using charcoal or wood because
those fires burn at higher temperatures.
To operate Skotti with charcoal or wood, proceed as follows:
This is how you set up your Skotti
It is best to take an empty bottle and fill it with wa-
ter. Now fill the water into the grease drip tray. The
bowl should be about 1 cm (0.4 inch) full of water.
Do not fill with water while the appliance is in
operation. Do not add water while the appliance
is still hot.
When you hear an audible click, the grill is locked
This is how you set up your Skotti
1. Before grilling with charcoal or wood, take off the burner pipe (3) and the
baffle plate (2).
2. Put the grill rack (1) on Skotti only with a low flame.
✔ You can now operate Skotti with charcoal or wood.
Tip
▶ To protect the environment, we recommend that you operate Skotti exclusive-
ly with gas.
5.6 Connecting the gas
Possible danger to life due to incorrect use of gas cartridges
▶ Use Skotti in gas operation with a standard EN417 propane/butane gas mix-
ture only, using approved cartridges up to a maximum of 500g.
▶ The resealable gas cartridge must have an appropriate thread for your gas
regulator (7/16 x 28 UNEF thread).
▶ Before connecting the gas cartridge, make sure the gaskets between the de-
vice and the gas cartridge are in working order and condition. Never use Skotti
with defective or worn out gaskets.
▶ Connect the gas cartridge outdoors only. Keep a safe distance from ignition
sources and other people.
▶ Avoid twisting the gas hose.
To connect the gas, proceed as follows:
1. Turn the end with the gas nozzle (4) clockwise gently onto the round end of the Skotti
burner tube. The end should fit snugly without using much force.
2. Close the gas tap with a hand-tight turn to the right (
priate gas cartridge.
3. Twist the gas cartridge onto the gas regulators and not the other way around
✔
The gas is connected.
14
EN
), before you connect the appro-