Skotti-grill SKOTTI Manual De Instrucciones página 15

5.7 Changing the gas cartridges
Possible Danger to life due to incorrect usage of gas cartridges.
▶ Before loosening the gas cartridge, check that the burner are no longer lit.
▶ Before changing the gas cartridge, check that it is empty, e.g. by shaking so
that any sloshing of liquid can be heard.
▶ Only change the gas cartridge outdoors and at a safe distance from sources
of ignition and other people.
▶ Avoid twisting the gas hoses.
To change the gas cartridge, proceed as follows:
6 THIS IS HOW YOU USE YOUR SKOTTI
6.1 Check before Ignition
To carry out safety checks each time before lighting , proceed as follows:
1. Check that the burner tube are not blocked. Loosen the blockage before
using the Skotti.
2. Check whether the gas seal and hose are OK.
3. Do not light the Skotti during a leak test.
4. A soap and water solution in a spray bottle can be used to check for leaks.
5. Use it to spray the gas hoses and the connections between the Skotti and
the gas cartridges.
This is how you set up your Skotti
1. Close the gas tap with a hand-tight turn to the
right ( ), before you release the gas cartridge.
2. Twist the gas cartridge off the gas regulator, not
the other way around.
➲ The gas cartridges have now been removed.
3. Before connecting, make sure that the seal
between the Skotti and the gas cartridges are in
place and in faultless condition. Never use your
Skotti with defective or worn seal.
4. Twist the new gas cartridge onto the gas regu-
lator and not the other way round.
✔
The gas cartridge have now been exchanged.
This is how you use your Skotti
6. Open the gas regulator.
➲ If there should be any leaks, small bubbles will appear.
7. If there are leaks, turn the gas regulator clockwise (
gas canisters.
Do not use the Skotti.
8. Before lighting, make sure that all parts are correctly assembled.
9. Before lighting, remove any fat or grease from the Skotti that may have re-
mained from previous grilling. Fat fires are dangerous and must be avoid-
ed.
✔
If everything is working properly, you can then light the Skotti.
6.2 Ignition
Possible Danger to life due to incorrect usage
and inattentiveness.
▶ The Skotti should not be exposed to any strong winds when in operation. The
ignition and flame control hole should always face away from the wind.
▶ Take care of yourself and your clothing when lighting. During preheating or if
the Skotti and/or the gas cartridge is shaken vigorously, gas can escape in liquid
form and cause flashes. Just as one example, long hair or loose clothing can
quickly burst into flame.
To ignite the Skotti, proceed as follows:
1. Turn the gas regulator on the gas cartridge a little to the left (
hear the gas flowing.
2. After about 1–2 seconds, ignite the gas in the burner tube with a lighter or
a match through the honeycomb ignition and flame control hole on the foot
part.
Possible Risk of explosion, fire, and fatal injuries from gas.
▶ If you cannot ignite the gas in the burner tube within 4 seconds, e.g. due to
wind, a faulty lighter or match, etc., stop trying.
▶ Immediately turn the gas regulator to the right (
▶ Wait at least 5 minute so that the gas can escape from the grill body. Other-
wise, there is an acute risk of explosion.
3. Check through the ignition and flame control hole after each attempt to
light it whether the gas in the burner tube has ignited.
4. If the flames go out, immediately turn the gas regulator to the right (
EN
) and unscrew the
), until you
).
).
15