Publicidad
Idiomas disponibles
Idiomas disponibles
10 Christmas Tree Lights With Remote Control
INTRODUCTION
To get the most out of your new product, please read this manual before use. Please also
save the manual in case you need to refer to it at a later date.
TECHNICAL DATA
10 × Christmas tree lights: Ø1.5 H13 cm
Battery: 1 x AAA batteries per light
(Batteries not included)
Remote control: 1 × CR2025 battery
(included)
Range: approx. 5 meter
For indoor use only!
USE
Unscrew the base of a Christmas tree
light. Insert battery. Check that the bat-
tery is correctly fitted. Screw the base
back on.
Repeat this procedure for all 10 lights.
Open
Close
Place the Christmas tree lights on the
branches of the Christmas tree using
the clips at the bottom of the Christmas
tree lights.
AAA
10
If you take the clips off the lights, they
can be used in most common holders
for Christmas tree lights.
Press the ON button on the remote
control to turn all the Christmas tree
lights on at once.
If not all the Christmas tree lights
turn on, move closer with the remote
control.
Press the OFF button on the remote
control to turn all the Christmas tree
lights off at once.
The built-in LEDs in the Christmas tree
lights cannot be replaced but have a
long service life.
If the lights grow weak, the batteries
need replacing.
If the range of the remote control re-
duces, replace the battery in the remote
control.
Remove the batteries if you do not in-
tend to use the Christmas tree lights for
a prolonged period before putting them
into storage.
Publicidad
