Fanimation TRIAIRE Custom MAD8515 Serie Manual De Instrucciones página 8

How to Assemble Your Ceiling Fan (continued)
5. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install the two
set screws with nuts in the downrod support. Securely
tighten the set screws with screwdriver then fully tighten
the nuts using a hex wrench. (Figure 5)
It is critical that the clevis pin in the downrod
support is properly installed and the set screws
and nuts are securely tightened. Failure to do
so could result in the fan falling.
6. Route wires and safety cable through motor coupling
cover, canopy screw cover and ceiling canopy. (Figure 6)
7. Reinstall the hanger ball on the downrod as
follows. Route the black/white, blue, red, gray and
yellow wires and safety cable through the hanger ball.
Position the pin through the two holes in the downrod
and align the hanger ball so the pin is captured in the
groove in the top of the hanger ball. Pull the hanger ball
up tight against the pin. Securely tighten the set screw
in the hanger ball. A loose set screw could cause fan
wobble. (Figure 7)
NOTE: All set screws must be checked, and retightened
where necessary before installation.
WARNING
Set Screws
and Nuts (2)
Ceiling
Canopy
Motor Coupling
Cover
8
Downrod
Figure 5
Canopy Screw
Cover
Figure 6
Figure 7
Figure 8
Clevis Pin
Hairpin Clip