Publicidad
Idiomas disponibles
Idiomas disponibles
Persons under 16 years of age must not operate the tool and persons
over 16 and under 18 must only use under close supervision
The operator and persons in the vicinity must wear appropriate safety
goggles, protective helmet, ear protection, protective gloves and safety
shoes during operations.
Always work with concentration. Do proceed with consideration
and do not operate the tool when not fully concentrated.
For further safety instructions refer to the enclosure!
Mounting the core drill tool on the
diamond drilling stand P-54190
Mounting the mounting plate
Dimensions of the motor unit
Insert the core drill tool with the affixed mounting plate into the drilling stand
which must be firmly anchored on the surface. Lock it with the turnstile (see
page 18).
Use the turnstile to open
the locking device of the
mounting plate. Take it
out and connect it to the
core drill as described
below.
The drilling stand P-54190 comes with a
mounting plate, a 10 mm fitting key and 4
hexagon hollow head plugs M8. The
mounting plate is fixed on the tool with the
fitting key so that the coupling on the
mounting plate is on the same side as the
gear change of the engine. The 4 plugs are
then inserted and tightened.
Publicidad
