Automatic Time Limitation; Deactivating The Acoustic Signal; Care And Cleaning; Hob - NEFF NK45 Serie Instrucciones De Uso

Automatic time limitation

If the hotplate is used for prolonged periods and the settings
are not adjusted, the automatic time limitation function is
activated.
The hotplate stops heating. The
heat indicator / flash alternatively in the display.
• œ

Deactivating the acoustic signal

When a symbol is touched, it is conformed by a short acoustic
signal. This signal can be deactivated depending on the model.
Set the hotplate to heat setting
1.
Switch off the hotplate.
2.

Care and cleaning

The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition

Hob

Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cool enough
before attempting to clean it.
Only use cleaning products specifically designed for hobs.
Follow the instructions provided on the packaging.
Do not use:
Undiluted washing-up liquid
■
Dishwasher detergent
■
Abrasive products
■

Fixing malfunctions

Malfunctions are usually due to small details. Before calling the
Technical Assistance Service, you should consider the
following advice and warnings.
Indicator Malfunction
none The electric power supply has been cut off. Use other electrical appliances to check whether there has been a
The appliance has not been correctly con-
nected following the connection diagram.
Electronic system malfunction.
The control panel is damp or an object is
" flashes
resting on it.
Electronic system malfunction.
+ number /
"§
š + number /
+ number
¡
There is an internal error in the operation.
"‹
* If the warning persists call the Technical Assistance Service.
Do not rest hot pans on the control panel.
, symbol and the residual
" ‰ ‹
.
„
When the control is turned to setting 0, the indicator goes off.
The hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
Touch and hold the
3.
acoustic confirmation signal sounds after this time has
elapsed.
The acoustic symbol can be reactivated. Proceed in the same
way as for deactivation.
Corrosive products such as oven sprays or stain removers
■
Sponges that may scratch
■
High-pressure or steam cleaners
■
The best way to remove stubborn stains is to use a glass
scraper. Follow the manufacturer's instructions.
Suitable glass scrapers can be obtained through the Technical
Assistance Service or from our online shop.

Hob frame

In order to avoid damage to the hob frame, follow the
indications below:
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
■
Solution
power cut.
Check that the appliance has been connected correctly according to
the connection diagram.
If in the above checks, the malfunction is not resolved, contact the
Technical Assistance Service.
Dry the control panel area or remove the object.
Unplug the hob from the mains. Wait about 30 seconds before plug-
ging it in again.*
Unplug the hob from the mains. Wait about 30 seconds before plug-
ging it in again.*
symbol for at least 5 seconds. An
˜
17