cosori CP267-FD Manual Del Usuario página 13

USING YOUR DEHYDRATOR
Operation
Note:
• Use the dehydrator in a warm, dry room, and
place on a stable, level, heat-resistant surface.
• Depending on humidity in the air and moisture
in the food, dehydration times may vary.
1. Place food on trays. Rearrange the trays
to fit thicker food items. The trays can
safely hold 3.5 kg / 7.7 lb of food. Avoid
overloading the trays or overlapping
food. Close the dehydrator door.
Note: To avoid scratching the inside of your
dehydrator, insert the tray with the smooth side of
the frame facing down [Figure
2. Plug in. The dehydrator will beep,
and the display will show "88:88". The
dehydrator will switch to standby mode
after 3 seconds, and the display will show
"00:00".
3. Press TEMP/TIME
temperature. The temperature will blink
on the display, and the
+
will light up. Use
temperature (35–75°C).
Note: Temperature changes in 1°C increments.
+ –
Press and hold or to change the temperature
rapidly.
4. Press TEMP/TIME
The time will blink on the display, and
the + and – buttons will light up. Use
– to change the time (0:30–48:00).
Note: Time changes in 30-minute increments.
Press and hold + or – to change the time rapidly.
1.1].
to choose
+ –
or buttons
–
or to change the
again to choose time.
+ or
5. Press START/STOP
The dehydrator will start heating.
STOP will stay lit, and the other buttons
will turn off. Temperature and time will
cycle on the display every 3 seconds.
Note:
START/STOP
• If you press
dehydration, the timer countdown will reset
and the dehydrator will go into standby mode.
• If using memory setting, press
ONCE, then press START/STOP
dehydrator.
6. Optionally, you can change the time
and temperature at any time by pressing
TEMP/TIME.
7. When the timer finishes, the display will
show "End" and heat will turn off. The
dehydrator will beep 5 times, and the fan
will stop.
8. Use a kitchen towel, heat-resistant glove,
or oven mitt to handle the trays.
Note: The dehydrator will always remember your
previous temperature and time settings.
Figure 1.1
to start dehydrating.
START/
again to stop
TEMP/TIME
to start the
EN
13