Bose L1 Pro8 Guia Del Propietario página 8

System Setup
Connecting Power
Plug the power cord into the Power Input on
1.
the L1 Pro.
2. Plug the other end of the power cord into a live
electrical outlet.
Note: Do not power on the system until after you've
connected your sources. See Connecting Sources
below.
3. Press the Standby Button. The LED will
illuminate white while the system is on.
Note: Press and hold the Standby Button for 10
seconds to reset the system to factory settings.
AutoOff/Low-power Standby
After four hours of no use, the L1 Pro will enter
AutoOff/Low-power Standby mode to save power.
To wake the system from AutoOff/Low-power
Standby mode, press the Standby Button.
Note: Disable AutoOff/Low-power Standby mode by pressing and holding all three Channel Parameter
Controls for 10 seconds, or via the Settings page in the Bose Music app. Enable AutoOff/Low-power Standby
mode by repeating this step. Disabling AutoOff/Low-power Standby mode will result in higher energy usage
when the L1 Pro is not in use.
Connecting Sources
Channel 1 & 2 Controls
Channel 1 and 2 are for use with microphones, guitars, keyboards,
or other instruments. The channel inputs are suitable for a wide
range of input types and will have the proper gain staging to
minimize noise when the channel volume is set for the desired
output level.
1. Connect your sound source to the Channel Input with the
appropriate cable.
2. Apply a ToneMatch preset—to optimize the sound of your
microphone or instrument—by pressing the Channel ToneMatch
Button until the LED for your chosen preset is illuminated.
Use MIC for microphones and use INST for acoustic guitars
and other instruments. Use OFF if you do not want to apply a
preset.
Note: Use the Bose Music app to choose custom presets from
the ToneMatch library. The corresponding LED will illuminate
green when a custom preset is selected.
3. Press the Channel Parameter Control to choose a parameter
to modify. The parameter name will illuminate white while it is
selected.
4. Rotate the Channel Parameter Control to adjust the level of the
selected parameter. The parameter LED will indicate the level of
the selected parameter.
Note: While Reverb is selected, press and hold the control for
two seconds to mute the reverb. While reverb is muted, Reverb
will flash white. To unmute reverb, press and hold for two
seconds while Reverb is selected. Reverb mute will reset when
the system is powered off.
8 • English
q w
q
L1 Pro8/Pro16 Portable Line Array System • Owner's Guide
PRO.BOSE.COM
e
w
INST
e
r