Publicidad
Idiomas disponibles
Idiomas disponibles
1.4 ASSEMBLY
EN
CAUTION:
Make sure that the socket, extension or
any attachment used with the tool to hold
fasteners is designed specifically for power
tools (Impacting tools).
Using the tool with attachments designed
for hand tools may break the attachments
and cause possible danger.
Also, Make sure that there is nothing
wrong on the attachment before operating.
NOTE:
• If a worn or deformed socket is used, the
square drive (retainer ring and pin) may
not enter the socket properly.
• When attaching or removing a bit, discon-
nect battery pack from tool or place the
switch in the center position (switch lock).
• Keep the temperature of the tool above
the freezing point (0 °C/32 °F) when
attaching sockets to or removing them
from the square drive on the tool. Do not
use excessive force when attaching or
removing sockets.
Attaching or Removing Bit
NOTE:
• When attaching or removing a bit, dis-
connect battery pack from tool or place
the switch in the center position (switch
lock).
1. Hold the collar of quick connect chuck and
pull it out from the tool.
2. Insert the bit into the chuck. Release the
collar.
3. The collar will return to its original position
when it is released.
4. Pull the bit to make sure it does not come
out.
5. To remove the bit, pull out the collar in the
same way.
CAUTION:
• If the collar does not return to its origi-
nal position or the bit comes out when
pulled on, the bit has not been properly
attached. Make sure the bit is properly
attached before use.
EYFLF1XA / EYFLF2XA / EYFLG1XA/ EYFLG2XA
12 mm
9 mm – 9.5 mm
6.35 mm
Attaching Socket (Pin type)
Remove the socket's rubber ring and pin.
[Fig.1]
Attach the socket to the tool.
Insert the pin. (Taking care to align the pin
holes on the socket and tool.)
Attach the rubber ring by sliding it into
place over the groove.
[Fig.2]
NOTE:
Be sure to attach the rubber ring to pre-
vent the pin from falling out.
Removing Socket (Pin type)
Remove the rubber ring.
Remove the pin.
Remove the socket from the tool.
[Fig.3]
Attaching or Removing
Bat tery Pack
1. To connect the battery pack:
Align the highlighted marker points and
attach battery pack.
• Slide the battery pack until it locks into
position.
[Fig.4]
2. To remove the battery pack:
Push down the button and slide the bat-
tery pack forward.
[Fig.5]
Attaching the tool hanger
[Fig.6]
2. OPERATION
WARNING
Do not inhale any smoke emitted from the
tool or battery pack as it may be harmful.
[EYFLF]
Before Using the Remote
Control (Available as an
optional accessory)
‒ 16 ‒
Publicidad
