Publicidad
Idiomas disponibles
Idiomas disponibles
Figure C
➢
Brake operation :
When the 24'' rear wheels are installed, the chair can be propelled by either the attendant or the chair occupant. If the attendant
is propelling the chair, they should propel the chair using the push handle at the rear and apply the castor brakes when the chair
is stationary. If the occupant is propelling the chair, they should use the handrims mounted on the side of the wheels to go,
manoeuvre and stop and then apply the brakes (above) when the chair is stationary.
CARE AND MAINTENANCE
Failure to care for and maintain your product may result in the risk of serious injury.
• Regularly clean by hand the product (all wheels, seats, and fixations) with a damp cloth and a mild detergent and
disinfectant. Do not use abrasive products, detergents or solvent-based products.
• Dry with a clean, dry soft cloth.
• The chair must be completely reviewed every year, with compulsory lubrication.
• It is recommended that the device is serviced annually.
• If the device is subject to heavy use and/or use in a multi user environment then we recommend the device is serviced
more frequently.
• Worn tyres, wheel bearings, wheels, brakes, leg rest locking mechanism, seat and back cushions, armrest cushions, quick
release pin, pot and lid, "E" clips) should be repaired, replaced, adjusted and/or lubricated if necessary.
• In case of malfunction, do not repair the product yourself. Consult an authorised dealer.
• Checklist :
To ensure optimal product life, check before each use and verify as follows:
Type of Control
Seat and backrest control
Fastenings control
Wheels control
Brakes control
Armrests and legrests control
DMI-F-06_Annexe 2_Notice.7
V2-25/04/2023
Before installation, loosen the two screws securing the brake clamp (shown in
Figure C.) Position the brake clamp on the top horizontal bar of the frame. Slide
the brake assembly into the approximate position shown in Figure C. Tighten the
two fixing screws to secure the brake. Check that the brake is in the correct
position by the following checks:
i. When released, the brake does not interfere with the tyre
ii. When applied, the brake stops the wheel
iii. The user can easily apply the brake
iv. When applied, the brake is lower than the seat.
This is important to avoid injury to the user during lateral transfer. If the position is
incorrect, loosen the two screws on the brake collar, reposition, retighten the two
screws and recheck.
Pusk the brakes forward to lock the wheel. Pull the brakes back to release the brake. Ensure
both brakes are applied when the chair is stationary and when the user is side transferring.
➢
Operation – 24'' rear wheels :
Method
Adjustment/Visual Control
Adjustment
Adjustment
Adjustment
Adjustment
Frequency
Before every use
Once a month
Once a month
Before every use
Once a month
Page 14 sur 23
Publicidad
