Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1. REMOVE THE PC CASE
Use the standard Philips screwdriver to remove
the screws and then remove the PC case
2. LOCATE THE M.2 PCIE SLOT AND
CONFIRM THERE ARE SCREWS
Locate the M.2 PCIe slot, ensure the SSD will fit,
and confirm there are screws present.
*The location of slots may vary by PC. Please check
your PC's user manual for more information.
**Generally speaking, the screws that secure the SSD in
place will be installed on the motherboard when the PC
is shipped from the factory.
3. ALIGN THE M.2 SLOT AND INSERT
THE SOLID STATE DRIVE
Use your small Phillips screwdriver to remove the
screws on the motherboard. Align the notches in
the SSD with the ridges in the PCIe slot, then
insert at a an angle. Give it a final push to ensure
it is securely in place.
* The slot has a foolproof design. Please insert the SSD
in the direction corresponding to the pins on the solid
state drive and the slot. Do not insert it forcibly to avoid
damage to the product.
4. FASTEN THE SCREWS TO SECURE
THE SSD
Use your small Phillips screwdriver to secure
the SSD into place.
Publicidad
