Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1. REMOVE YOUR PC'S BACK PLATE
Use your standard Phillips screwdriver to
remove the screws from the back plate.
*If you are unsure how to do this, refer to your user
manual
2. LOCATE THE M.2 PCIE SLOT AND
CONFIRM THERE ARE SCREWS
Locate the M.2 PCIe slot, ensure the SSD will fit
and confirm there are screws present.
*The location of slots may vary by PC. Please check
your PC's user manual for more information.
**Generally speaking, the screws that secure the SSD in
place will be installed on the motherboard when the
laptop is shipped from the factory.
3. ALIGN THE M.2 SLOT AND INSERT
THE SOLID STATE DRIVE
Use your small Phillips screwdriver to remove
the screws on the motherboard. Align the
notches in the SSD with the ridges in the PCIe
slot, then insert at a an angle. Give it a final
push to ensure it is securely in place.
*The slot has a foolproof design. Please insert the SSD
in the direction corresponding to the pins on the solid
state drive and the slot. Do not insert it forcibly to avoid
damage to the product.
4. FASTEN THE SCREWS TO SECURE
THE SSD
Use your small Phillips screwdriver to secure
the SSD into place.
*Do not overtighten the screws
Publicidad
