Futurelight DJ-LED CF-100 Manual Del Usuario página 23

The maximum drop distance must never exceed 20 cm.
A safety rope which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the DJ-LED CF-100 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In),
which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode for the master-device. Set the respective Slave-mode for all slave-devices.
Please note: The function G-3- is only meant for service-purposes. Please do only use this function if you
want to set the unit shortly into standby mode.
Display close time
With this function you can shut off the LED display.
Remote Control socket
If you wish to lock the light output - via an optional FUTURELIGHT Easy-4 remote control, connect your
Easy-4 remote control to the remote control socket.
The remote control Easy-4 can be used for switching the gobos and the Auto/Manual mode. In Auto Mode,
the gobos are switched sound-controlled. In Manual Mode, the gobos are switched via remote control.
23/52 51837505_V_1_0.DOC