Descargar Imprimir esta página

Futurelight DJ-LED CF-100 Manual Del Usuario página 25

Publicidad

Idiomas disponibles

Idiomas disponibles

Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the DJ-LED CF-100 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.
Stand Alone operation
In the Stand Alone mode, the DJ-LED CF-100 can be used without controller. You can do without a
controller as the DJ-LED CF-100 features a built-in microphone, which provides automatic sound control.
Disconnect the DJ-LED CF-100 from the controller and select the desired "Master Mode".
Master/Slave-operation
Connect the master and slave-devices and adjust the settings as desribed above.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the DJ-LED CF-100 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each DJ-LED CF-100
correctly and independently from any other fixture on the DMX data link.
If two, three or more DJ-LED CF-100 are addressed similarly, they will work similarly.
For address setting, press the Mode-button until the display shows „A.001" and set the desired address via
the Up/Down-buttons.
Controlling:
After having addressed all DJ-LED CF-100, you may now start operating these via your lighting controller.
International
L
N
25/52
51837505_V_1_0.DOC

Publicidad

loading