Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
After switching on, the DJ-LED CF-100 will automatically detect whether DMX 512 data is received or not. If
the data is received, the display will show "A.001" with the actually set address. If there is no data received
at the DMX-input, the display will show "A001".
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the DJ-LED
CF-100.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control-channel 1 - Gobos
Decimal Hexad. Percentage S/F
0 7
00 07
0% 3%
8 15
08 0F
3% 6%
16 23
10 17
6% 9%
24 31
18 1F
9% 12%
32 39
20 27
13% 15%
40 47
28 2F
16% 18%
48 55
30 37
19% 22%
56 63
38 3F
22% 25%
64 71
40 47
25% 28%
72 79
48 4F
28% 31%
80 87
50 57
31% 34%
88 95
58 5F
35% 37%
96 103
60 67
38% 40%
104 111
68 6F
41% 44%
112 119
70 77
44% 47%
120 127
78 7F
47% 50%
128 143
80 8F
50% 56%
144 159
90 9F
56% 62%
160 175
A0 AF
63% 69%
176 191
B0 BF
69% 75%
192 207 C0 CF
75% 81%
208 223 D0 DF
82% 87%
224 239
E0 EF
88% 94%
240 255
F0 FF
94% 100%
Control-channel 2 - Gobo rotation
Decimal Hexad. Percentage S/F
0 127
00 7F
0% 50%
128 255
80 FF
50% 100%
Control-channel 3 - Strobe
Decimal Hexad. Percentage S/F
0 7
00 07
0% 3%
8 247
08 F7
3% 97%
248 255
F8 FF
97% 100%
S Gobo 1
S Gobo 2
S Gobo 3
S Gobo 4
S Gobo 5
S Gobo 6
S Gobo 7
S Gobo 8
S Gobo 9
S Gobo 10
S Gobo 11
S Gobo 12
S Gobo 13
S Gobo 14
S Gobo 15
S Gobo 16
S Rot. gobo 1
S Rot. gobo 2
S Rot. gobo 3
S Rot. gobo 4
S Rot. gobo 5
S Rot. gobo 6
S Rot. gobo 7
S Rot. gobo 8
F Forwards gobo rotation with decreasing speed
F Backwards gobo rotation with increasing speed
S Closed
F Strobe-effect with increasing speed
S Open
26/52
Feature
Feature
Feature
51837505_V_1_0.DOC
Publicidad
