Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the cutting blade
(Fig . K)
m
CAUTION! When the saw blade
inserted to the blade guard, do not touch the sharp cutting edge .
To avoid injury, wearing suitable protective gloves is required .
NOTE: Before carrying out any work on the product, ensure
that the rotation direction switch
prevents unintentional switching on .
Install the cutting attachment
This prevents the spindle
[
24 ]
screw
to be removed .
Loosen the screw
PH2 or SL6 screwdriver (not included) .
Remove the screw
Hold the product in an upright position . Swing it gently and
allow the cutting blade
guard (Fig . M) .
Insert a new cutting blade
(Fig . N) .
Ensure the cutting blade
[
26 ]
spindle
(Fig . L) .
Tighten the screw
The attachment is ready for use again .
NOTE: Replacement cutting blades
OWIM .
[
5 ]
19 ]
[
to the product .
[
26 ]
from rotating and allows the
24 ]
[
in a counter‑clockwise direction by using a
24 ]
[
from the spindle
[
25 ]
to slide out slowly from the blade
25 ]
[
into the cutting attachment
25 ]
[
is sitting tight in the slot of the
[
24 ]
in a clockwise direction .
25 ]
[
is to be removed from or
is in the middle position . This
26 ]
[
.
25 ]
[
are available from
[
19 ]
GB/MT
173
Publicidad
