Publicidad
Idiomas disponibles
Idiomas disponibles
C
Useful information
Troubleshooting
CAUTION!
Before troubleshooting, disconnect the power supply.
Only a qualified electrician of competent person must do
the troubleshooting that is not in this manual.
IMPORTANT!
There are some sounds during normal use
(compressor, refrigerant circulation).
Problem
Possible cause
Mains plug is not plugged in
or is loose
Appliance does not
Fuse has blown or is defective Check fuse, replace if necessary.
work
Socket is defective
Temperature is set too cold
Appliance freezes too
or the appliance runs at MAX
much
setting.
Temperature is not properly
adjusted.
Door was open for an extended
period.
The food is not frozen
A large quantity of warm food
enough.
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
16
Solution
Insert mains plug.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
P l e a s e l o o k i n t h e i n i t i a l
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please look in the installation
location section.
EN
C
Useful information
Problem
Possible cause
Heavy build-up of
Door seal is not air-tight.
frost on the door seal.
Appliance is not level.
The appliance is touching the
wall or other objects.
Unusual noises
Acomponent, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.
17
Solution
Carefully warm the leaking sections
of the door seal with a hair dryer
(on a cool setting). At the same time
shape the warmed door seal by hand
such that it sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
EN
Publicidad
