Princeton Tec VIZZ II Instrucciones De Operacion Y Mantenimiento

VIZZ II
®
INTRINSICALLY SAFE HEADLAMP
Operating and Maintenance Instructions
ENGLISH:
Battery Installation
- See Figure 1
• 3 AAA
• Alkaline (LR03)
Princeton Tec cares about the environment and recom-
mends recycling batteries. For more information about
battery recycling, please go to
https://batterysolutions.com
Observe proper battery polarity. Improper installation of
the batteries will damage the light and void the warranty.
!
WARNING
• Never mix fresh and used batteries.
• Never mix different battery brands or chemistry types.
• Always remove drained batteries immediately.
• Remove batteries during long periods of storage.
The Vizz II battery compartment has a waterproof seal.
It is important to keep this seal free from dirt and away
from harsh chemicals in order to preserve waterproof
integrity. Inspect the seal every time batteries are
changed. If dirt is present, wipe gently with a damp
cotton swab and mild soap until dirt is removed.
Switch Operation - See Figure 2
From off:
-
Press 1x
Press & Hold: -
-
Press 2x
Press & Hold: -
Press 1x after more than 1 second
in any mode-
Five second hold -
Vizz II will blink 3x when lockout is achieved.
Removal and replacement of batteries will also reset
Vizz II to unlocked state.
Troubleshooting
If the Vizz II fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper installation is confirmed.
• Check circuit board for water (the seal may have been
compromised by improper rear cover installation or
dirty seal). The light will resume normal operation
once the water is shaken or blown out and the light
is left open until completely dry. If the light has been
contaminated with salt water, flush the unit with fresh
water and dry as described above.
USA Lifetime Warranty - International
10-YearWarranty
Due to International regulations, Princeton Tec's lifetime
warranty can only be offered to customers in the USA.
Princeton Tec offers a 10-year warranty to our cus-
tomers outside the USA. FULL WARRANTY - Princeton
Tec warrants this product to be free from defects in
Figure 1 – Battery Replacement
1
Figure 2 – Switch Operation
Figure 3 – Performance
Modes
HIGH SPOT
LOW SPOT
HIGH FLOOD
LOW FLOOD
DISTANCE (m)
(ANSI FL-1 Standard)
Runtime is defined as the duration of time from the initial light output value—defined as 30 seconds after the
point the device is first turned on—using fresh batteries, until the light output reaches 10% of the initial value.
Reserve time is the duration of time from 10% of initial light output value down to 0.25 lux
workmanship and materials under normal use for as
long as you own this product. This warranty covers all
of the component parts of the product except batteries.
This warranty does not cover deterioration due to normal
wear or damage due to misuse, alteration, negligence,
accidents, or unauthorized repair. Princeton Tec will
Spot 100%
repair or replace parts which are defective in workman-
Dimming
ship or materials. Your authorized Princeton Tec Dealer
Flood 100%
and Princeton Tec are the only facilities authorized to
Dimming
repair the product. After (3) unsuccessful attempts to
repair the product, you have the right to elect replace-
Off
ment of the product or a refund of the purchase price
Lockout/Unlock
less allowance for use of the product. NO INCIDENTAL
OR CONSEQUENTIAL DAMAGES ARE INCLUDED IN THIS
WARRANTY. (Some states do not allow the exclusion or
limitation of incidental or consequential damages, so
the above limitations or exclusions may not apply to
you.) This warranty gives you specific legal rights, and
you may also have other rights which vary from state
to state.
Princeton Tec reserves the right to change product
specifications without notice.
FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol A (BpA) a
chemical known to the State of California to cause birth
defects or other reproductive harm.
Return Policy
If your light fails to operate, follow these simple steps:
1. Check batteries. Replace if necessary.
2. To send your light in for repair or replacement, first
contact Princeton Tec customer service on
1-800-257-9080 to request an RMA number. Please
have your light model, date of purchase and a brief
description of the fault you are experiencing.
2
Press 1x:
Spot 100%
Press & hold:
Dimming
Press 2x:
Flood 100%
Press & hold:
Dimming
Lumens Runtime Beam Pattern
200 3.5
12 66h
50 45h
2 55h
0 10 16
3 4
After 1s in any mode:
Press 1x from On:
Off
Press 5s:
Lock-Out
Press 5s from Lock:
Unlock
36
No warranty repairs will be accepted without an RMA
number.
3. Return the light without batteries to: Princeton Tec,
PO Box 8057 Trenton NJ 08650. Postage due and
freight collect items will not be accepted.
4. Upon receipt your light will be processed in about
two weeks. Please allow additional time for return
transportation from NJ.
Intrinsically Safe Apparatus
Princeton Tec Vizz for use in hazardous locations only as
to intrinsic safety class I, II, III; Division 1&2; Groups A-G;
T4; -20°C < 40°C. Warning- substitution of components
may impair safety. Change batteries in an area known to
be non-hazardous. Do not mix new batteries with used,
do not mix
batteries from different manufacturers. Use with three
AAA batteries, Duracell: MN2400
UL 913 ISSUE:2006/07/31 ED:7 REV: 2011/09/23 UL
CAN/CSA C22.2#157
ISSUED:1992/06/01 ED:3 (R2012)
Conforms to UL 913 Eighth Edition, Dated
December 6, 2013. Certified to
CAN/CSA-C22.2 No. 157-92 June 2003.
Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
Reserve
30h
45h
97h
6h
60