Cavist CAVC28 Manual De Usuario página 7

ELECTRONIC CONTROL
You can display the temperature in either Fahrenheit or Celsius by pressing the °F/°C button.
You may change the temperature as you wish by pressing the UP or DOWN buttons on the
control panel. The set temperature will increase by 1ºF or 1ºC for each depression of the UP
button. The temperature will decrease by 1ºF or 1ºC for each depression of the DOWN
button. Once you have set the desired temperature, the display will flash for 5 seconds and
then revert to the internal cabinet temperature.
You can turn the interior light ON or OFF by pressing
When you press both UP and DOWN buttons for at least (3) three seconds, you get the
temperature readout either in Fahrenheit or Celsius.
NOTE: After you select your desired temperature the display will revert to show the current
temperature inside the cabinet, but it will gradually fall as it reaches your set temperature.
NOTE: The temperature displayed may deviate from your set temperature. The internal
temperature varies constantly due to the natural cooling cycle, the door being opened, the
introduction of new bottles, or air variations around the position of the thermostat. This is not
a sign of malfunction or failure of the drinks cooler.
V. PARTICULAR PRECAUTIONS
In order to function at its potential, this need to be placed on flat floor, with 2cm spaces at
•
each side and 10cm at the backside.
Use the cooler in a horizontal place.
•
Avoid direct sunshine and carry high temperature.
•
Do not put any food or hot drink into the cellar.
•
Do not place heavy articles on the top of the cellar.
•
HANDLE INSTALLATION
To install the door handle follow the below steps:
the button.