Publicidad
Idiomas disponibles
Idiomas disponibles
Gasket
Washer
Nut
1. Install the Spout
From the bottom of the spout, slide the gasket onto the spout
shank.
Insert the spout into the spout mounting hole (middle hole).
From the underside of the sink, slide the metal washer and nut
onto the spout shank.
Position the metal washer so the second hole faces the rear of the
sink.
Tighten the nut with a wrench. Do not overtighten.
Insert the plastic washer and rubber gasket into the top of the
supply tee.
Thread the supply tee onto the spout shank until hand tight.
Align the arms of the supply tee so they face the left and right
sides of the sink.
Kohler Co.
Spout
Rubber
Gasket
3
Plastic
Washer
Tee
113032-2-AB
Publicidad
