Makita GN420CLZK Manual De Instrucciones página 6

ENGLISH (Original instructions)
SPECIFICATIONS
Dimensions (L X W X H)
Nail length X Shank diameter
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change with-
out notice.
• Specifications and battery cartridge may differ from country to country.
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
Container under pressure, keep away
from temperatures over 50°C (for ex. sun
radiation) Keep container in a well venti-
lated place.
Use only outside or well ventilated rooms.
Do not breathe gas.
Do not use near flames or sprays on
heated surfaces. In use, may form flamma-
ble/explosive vapour-air mixture.
Do not damage, puncture or burn even
after use.
Wear safety glasses.
Wear ear protection.
Keep fingers away from trigger when not
driving fasteners to avoid accidental firing.
Use only in ventilated area to avoid nausea
and unconsciousness. Never use tool
in combustible atmospheres. The tool
exhaust may ignite flammable materials.
Do not use on scaffoldings, ladders.
Warning: hot surface!
Do not touch around this symbol. Touching
the surface may cause burns or injuries.
Model
Nail capacity
Net weight
20 nails (2strips)
315 mm X 108 mm X 390 mm
3.6 kg
Nail L :15 mm - 40 mm d : 2.6 mm - 3.1 mm
Only for EU countries
Ni-MH
Due to the presence of hazardous com-
Li-ion
ponents in the equipment, waste electrical
and electronic equipment, accumulators
and batteries may have a negative impact
on the environment and human health.
Do not dispose of electrical and electronic
appliances or batteries with household waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and on accumulators and batteries
and waste accumulators and batteries,
as well as their adaptation to national law,
waste electrical equipment, batteries and
accumulators should be stored separately
and delivered to a separate collection point
for municipal waste, operating in accor-
dance with the regulations on environmen-
tal protection.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Intended use
The tool is intended for securing a thin steel plate to the
concrete.
Noise
The typical A-weighted noise level determined accord-
ing to EN ISO 11148-13:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total value determined according to EN ISO 11148-13:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
6 ENGLISH
GN420C
40 nails (4strips)
430 mm X 108 mm X 390 mm
3.8 kg
D.C. 7.2 V
) : 96 dB (A)
pA
) : 100 dB (A)
WA
2
) : 3.5 m/s
h
2