Selco WU 3000 Instrucciones De Uso página 12

2 INSTALLATION
Installation should be performed only by expert
personnel authorised by the manufacturer.
During installation, ensure that the power source is
disconnected from the mains.
2.1 Lifting, transport and unloading
procedures
- The system is not equipped with specific lifting gear.
Do not underestimate the weight of the equip-
ment: see technical specifications.
Do not move or position the suspended load
above persons or things.
Do not drop or apply undue pressure on the
equipment.
2.2 Positioning of the equipment
Keep to the following rules:
- Provide easy access to the equipment controls and connec-
tions.
- Do not position the equipment in very small spaces.
- Do not place the equipment on surfaces with inclination
exceeding 10° from to the horizontal plane.
- Position the equipment in a dry, clean and suitably ventilated
place.
- Protect the equipment against pouring rain and sun.
2.3 Connection
The cooling unit is provided with a connector (1) for connection
to the power source.
The cooling unit is provided with a connector (2) for connection
to the power source.
12
Disconnect the power supply before every opera-
tion!
- Open the door on the bottom of the power source by remo-
ving the two screws.
- Connect the male connector (1) of the cooling unit to the
female connector (3) of the power source.
- Connect the male connector (2) of the cooling unit to the
female connector (4) of the power source.
2.4 Installation
- Put the WU on the GT and block it with the 4 screws (1).
- Position the power source above the cooling unit and secure
it by means of the screws (2).
Perform the following operations before starting
the unit:
- Remove the refill neck cap.
- Remove the sealing cap from the refill neck, levering by
means of a tool on the edge of the cap.
- Fill the tank with cooling liquid if necessary.
- Keep apart the sealing cap for future transport of the unit.
- Connect the blue hose of the cable bundle (1) to the appropri-
ate outlet quick connector (2) (blue colour - symbol
- Connect the red hose of the cable bundle (3) to the appropri-
ate inlet quick connector (4) (red colour - symbol
).
).