Publicidad
Idiomas disponibles
Idiomas disponibles
1-2. Insert the fixed panel's bottom seal strip (N) at the base of the return panel (W). Cut the surplus part with a cutter to
size, about 40mm from the panel's edge.
3. Place the return panel 's clamp (S) on the base.
4. Mark the positions of holes of the return panel 's clamp (S) with a pencil, and drill pilot holes with a ø4mm (5/32in) drill bit.
5. Fix the return panel 's clamp (S) with the screw (CC). Ensure the plastic gasket in the guide is in place as it protects the
fixed glass panel.
6-7 Place the return panel (W) into the wall track (B) and the return panel 's clamp (S).
Note: The wall track (B) allows you to adjust the position of the fixed glass panel (W). Adjusting the depth and/or
giving the fixed glass panel a slight angle allows for precise alignment with the door.
8. Install the support anchor (V) to the return panel (W).
9. Drill the return panel (W) with Φ 3mm (1/8in) in 3 places.
10. Secure the wall track (B) using screws (DD), fittings (FF) and caps (EE).
1
N
N
3
S
5
CC
S
7
S
RETURN PANEL INSTALLATION
40mm
Helpful Hint
Add a drop of
silicone in the
holes before
inserting the
screws
8
W
N
9
V
10
4
Φ4mm
5/32in
6
W
DD
Φ3mm
EE
1/8in
FF
2
W
N
B
10
Publicidad
