Safety Instructions; Operating Manual - Electric Hot Air Generator - Trotec TDS 50 Manual Operativo

safety instructiOns

m
Please read the instructions carefully and
thoroughly before assembling, using or
cleaning the appliance. The use of the heater can
cause severe injury due to burns, fire or electrical
discharge.
This appliance is transportable and made especially
for closed quarters such as warehouses, shops and
homes, as well as for humid and damp quarters
such as construction sites. The appliance complies
with directive EN 60335-2-30/1998, Keymark all.B
control, and therefore directive B.T. 73/23/EEC and
93/68EEC.
• Keep the appliance at a minimum-security distance of
0.5 metres from combustible materials. Never use the
appliance in rooms where petrol, solvents, paints or
any other substance that gives off combustible gases,
are kept, or near curtains or other drapery.
• Keep the appliance out of the reach of children and
animals.
• Only u se t he a ppliance w ith a p ower s upply t hat c omplies
with the frequency and voltage requirements specified
on the rating plate.
• Use only three wire extension power cables with ground
wire and adequate lengths.
• Unplug the appliance from the outlet when not in use.
• The appliance should never be positioned directly
under outlets.
• Should the appliance be left temporarily in insecure
conditions, make sure that it cannot be used and
that the plug is disconnected.
• Do not use this heating device near washbasins,
bathtubs, showers or swimming pools.
• Before beginning any kind of maintenance or repairs
on the appliance make sure the plug is definitely
disconnected from the outlet.
• Do not cover the appliance; it could cause over-
heating.
B - 1
Operating manual – electric hOt air generatOr
unpacking
• Remove all the material used to pack the appliance
for transportation.
• Remove all the objects from the box.
• If the heater looks damaged, immediately inform the
retailer where the appliance was bought.
functiOning
m
read the instructions in the safety in-
formation section thoroughly. the ins-
tructions must be followed carefully in order for
the heater to function safely.
Make sure the electric cable is not damaged in any way.
If the electric cable is damaged it must be immediately
replaced by the manufacturer, by the Service Center or by
specialized personnel only. Make sure that the electrical
characteristics of the outlet correspond to the require-
ments stated in the instruction booklet and/or on the ra-
ting plate found on the appliance. Place the appliance in
an upright position.
TURNING ON THE HEATER
Plug the electric cable into the outlet. Rotate the knob
to the required position:
1. fan only 2. minimum
SWITCHING OFF THE HEATER
Let the fan run for 3 minutes before turning the heater
off. Rotate the knob to the "0" position.
REGULATING THE THERMOSTAT
By rotating the knob that controls the thermostat, you
can regulate the room temperature.
When the desired temperature is reached the thermo-
stat automatically switches the resistance off but the
fan continues working.
3. maximum
G