Publicidad
Idiomas disponibles
Idiomas disponibles
4
UNPACKING
Do not attempt to assemble or use this product without all of the necessary parts.
If any parts are missing, please contact our helpline at (800) 541-7027 and await
the arrival of the missing parts. Use of this product with damaged or missing parts
could result in serious personal injury.
Before assembly, make sure that the tool is switched off and the battery is
removed.
Do not attempt to modify this product or create accessories not recommended for
use with this power head.
PACKING LIST
- Green Machine
Cordless Snow Blower
®
- Snow discharge deflector
- Handle Assembly
- Operator's manual
- 62V Battery Pack
- Battery Charger
Follow these unpacking instructions to begin operating your Green Machine
Snow Blower.
1.
Carefully remove the tool and all accessories from the box.
2.
Inspect the tool carefully to make sure that nothing was damaged during transportation.
3.
Once you have confirmed that the tool is complete and working, dispose of all
packing materials using responsible recycling and disposal practices.
4.
If any parts are damaged or missing, please contact our helpline or return the
product to the place of purchase.
5.
Charge your battery pack fully before operation.
Page 12-English
Cordless
®
GREEN MACHINE 62V CORDLESS SNOW BLOWER
5
ASSEMBLY
Always be sure that the snow blower is switched off and the battery pack is
removed before carrying out any work on the tool. Failure to switch off and remove
the battery pack may result in serious personal injury from accidental start-up.
Never start the snow blower unless it is completely assembled. Operation of the
tool in a partially assembled state may result in serious personal injury from
accidental start-up.
Danger of explosion if the battery is incorrectly replaced. Replace only with the
same or equivalent type.
5.1 ASSEMBLE THE HANDLE
NOTE: Assemble the handle before operation.
1.
Loosen the four locking knobs that pre-assemble on the lower handle and remove
the four locking knobs and bolts. (Fig.2A).
2.
Lift the upper handle assembly, align the holes in the side rails with the holes in
the lower handle, then secure the handle assembly with the bolts and locking
knobs. (Fig.2B)
There are three height adjustment holes in the handle, select the preferred
3.
operating position according to your height. (Fig.2C)
Locking knob
Bolt
Lower handle
Locking knob
F
. g i
2A
F
. g i
To adjust the handle height:
1.
Loosen the two upper locking knobs and remove the two bolts (Fig.2C). Save them
for reassembly.
GREEN MACHINE 62V CORDLESS SNOW BLOWER
Lower operation position
Middle operation position
Upper operation position
2B
F
. g i
2C
Page 13-English
Publicidad
