Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Check to ensure that the power switch is set to off before battery assembly.
1.
Raise the battery cover. (1, Fig.4)
2.
The snow blower is equipped with two battery compartments, which accommodate
two battery packs at the same time.
Align the ribs of the battery pack with the mounting slots in the battery port. Insert
3.
the battery pack into the battery compartment until you hear a "click". Ensure
that the latch snaps into place and the battery feels secure. (2, Fig.4）
Insert the other battery pack into the other battery compartment in the same way.
4.
Close the battery cover.
5.
1
TO REMOVE THE BATTERY PACK:
Serious injury could result if the battery pack falls. Remove the heavy battery pack
with caution.
1.
Turn off your snow blower.
2.
To detach the battery pack, depress the battery-release button to disengage the
battery from the latch (1, Fig. 5)
Lift it out of the compartment. (2, Fig. 5).
3.
1
Battery-release button
Page 16-English
Install
Battery
2
F
. g i
4
2
F
. g i
5
GREEN MACHINE 62V CORDLESS SNOW BLOWER
6.2 START/STOP THE SNOW BLOWER
Use the unit as intended to avoid damage to the machine or yourself.
Only switch the motor on when your hands and feet are away from the rotating parts.
Ensure that other people and pets remain at least 100' (30m) away from the snow
blower when it is in use.
NOTE: Your snow blower GMSB6200-DS comes equipped with a heating handle to warm
hands in cold operating conditions. The handles start heating as soon as the
auger-switch handle is engaged. Work gloves are recommended while operating to
protect the user from the elements.
To Start the Snow Blower
1.
Ensure that the handle assembly is securely adjusted to the appropriate height,
the snow discharge guide assembly is mounted properly, and the chute and
chute deflector is adjusted to an appropriate position.
Press the power button and press down the auger-switch handle to engage the
2.
auger (Fig.6).
3.
The speed of the auger can be adjusted to control the throwing distance.
To increase the speed, push the auger-speed-control lever forward. Select the
4.
speed suitable for your task.
5.
To decrease the speed, pull the auger-speed-control lever back to the neutral position.
The Auger starts turning as soon as the motor is started.
The Auger continues to rotate for a little while after the motor is switched off.
Always remove the battery pack from the power head during work breaks and after
finishing work.
If the snow gets stuck in the chute, do not try to remove it before releasing the auger
switch handle.
Do not put your hand inside the chute or auger.
To Stop the Snow Blower
1. Fully release the auger-switch handle.
GREEN MACHINE 62V CORDLESS SNOW BLOWER
Auger Speed Control Lever
Auger-Switch handle
Safety push-button
F
. g i
6
Page 17-English
Publicidad
